SITRANS F M
6. Installation of transmitter
57
6.4
Transmitter
Cleaning unit
1. Fit the SENSORPROM
®
memory unit on the connection board supplied with the cleaning unit.
The SENSORPROM
®
unit is delivered mounted in the terminal box of the sensor. The
connection board supplied with the transmitter is not used.
2. Mount the guide rails into the rack system as shown. Distance between guide rails is 20 TE.
Guide rails are supplied with the rack system and not with the transmitter.
3. Mount the connection board as shown. The mounting screw must be installed just in line with
the guide rails.
4. Connect the cables as shown under "Electrical connection", chapter 7.
5. Select AC-cleaning or DC-cleaning mode at the switch located on the base of the cleaning unit.
6. Insert the cleaning unit and the transmitter into the rack system.
To Next Page
Loading...
