Page 118 MultiRanger 100/200 – INSTRUCTION MANUAL 7ML19981FB05
mmmmm
Parameters
Index types
Name Description # of indexes
Global This parameter applies to the entire unit n/a
View only This parameter can not be set, only viewed n/a
Breakpoint Indexed by breakpoint
Parameter
dependent
Dimension Indexed by PMD dimension up to 7
Discrete Input Indexed by discrete input 2
Echo Profile Indexed by stored echo profile 10
Level
1
1.
MultiRanger 100: The two level points are: Transducer One and Trans-
ducer Two.
Level point typically has 1 index in Single Point Mode (standard), and 2
indexes in Dual Point Mode (optional).
MultiRanger 200: The three level points are: transducer 1, transducer 2,
and the calculated point which can be difference (P001=4) or average
(P001=5).
Level point typically has 1 index in Single Point Mode (standard), and 2
indexes in Dual Point Mode (optional). A third index is available in both
modes when Operation (P001) is set for DPD (P001=4) or DPA (P001=5).
Indexed by level point 1, 2 or 3
mA input
1
Indexed by mA input 1
mA output
1
Indexed by mA output 0 or 2
Comm. Port Indexed by communications port 2
Relay Indexed by relay 3 or 6
Transducer
2
2.
MultiRanger 200: The number of indexes available in Single Point Mode
(standard) is typically 1, but can be expanded to 2 if Operation (P001) is
set for DPD (P001=4) or DPA (P001=5).
In Dual Point Mode (optional), the number of available indexes is
always 2.
Indexed by transducer 1 or 2
To Next Page
Loading...
