Siemens S120 - Page 114

Power Modules
4.2 Blocksize Power Modules (PM240-2)
AC Drive
114 Manual, (GH6), 04/2014, 6SL3097-4AL00-0BP4
Line voltage 3-phase 380 … 480 VAC ± 10%
Internal
Push-through
Order number
without integrated line filter
with integrated line filter
6SL3210–
1PE21-1UL0
1PE21-1AL0
6SL3210–
1PE21-4UL0
1PE21-4AL0
6SL3210–
1PE21-8UL0
1PE21-8AL0
6SL3211–
1PE21-8UL0
1PE21-8AL0
Cooling air requirement
m
3
/s
0,0092
0,0092
0,0092
0,0092
24 VDC supply
for the Control Unit
A
1,0
1,0
1,0
1,0
Rated input current
2)
with/without integrated line reactor
A 13,3 17,2 22,2 22,2
Class J UL fuses
Rated current
Short-circuit current rating
SCCR
A
kA
20
65
25
65
35
65
35
65
NH fuses
IEC 60947
Rated current
A
3NE 1814-0
20
3NE 1815-0
25
3NE 1803-0
35
3NE 1803-0
35
Resistance value
of the external
braking resistor
Ω ≥ 75 ≥ 75 ≥ 75 ≥ 75
Max. cable length
to braking resistor m 15 15 15 15
Line supply connection
L1, L2, L3,
PE
Screw-type terminals
cable cross-section: 1.5 … 6 mm
2
Tightening torque: 0.6 Nm
Motor connection
U2, V2, W2
DC-link connection, connection for
braking resistor
DCP/R1, DCN, R2
PE connection
On line connector
Max. motor cable length
3)
shielded/unshielded
m
50 / 100
Degree of protection
IP20
IP54
Weight
Without line filter
With line filter
kg
kg
2,9
3,1
2,9
3,1
3,0
3,2
3,6
3,9
1)
Rated output of a typical standard induction motor at 400 V.
2)
The input current depends on the motor load and line impedance. The input currents apply for a load with the type rating
(based on I
rated
) for a line impedance corresponding to u
k
= 1%.
3)
Max. motor cable length 50 m (shielded) for PM240-2 Power Modules with integrated line filter to maintain the limit
values of EN 61800-3 Category C2.
4)
Power loss in the cabinet: 0,045 kW. The remaining power loss is dissipated via the heat sink.