08.2012 Parameterizing Steps
Siemens AG 6SE7087-6QX70 (Version AN)
SIMOVERT MASTERDRIVES Compendium Motion Control 6-27
By using the DriveMonitor PC program, you can upload parameter sets
from the units, store them on the hard disk or on floppy disks and
transfer them back to the units by download. You have the additional
possibility of editing the parameters off-line and of creating parameter
files especially for your application. These files do not have to contain
the complete parameter scope. They can be limited to parameters that
are relevant for the particular application.
On downloading with DriveMonitor, no power section data are written to
protect the device. Similarly, overwriting of the communication
parameters and the PIN enable are prevented.
Parameter number Parameter name
P060 Menu selection
P070 Order No. 6SE70..
P072 Conv.current(s)
P073 Conv.power(s)
P700 IF bus address
P701 IF baudrate
P702 IF no. of PKW
P703 IF no. of PZD
P836 Optional card data download
P850 – P899 OP special parameters
P918 CB bus address
P952 Number of faults
P970 Factory setting
P971 EEPROM accept.
U976 Product number
U977 PIN
Table 6-6 Parameters that cannot be changed on downloading with DriveMonitor
Download with
DriveMonitor
To Next Page
Loading...
