Siemens simovert masterdrives Compendium

02.2004 Communication / CBC CANopen Communication Board
Siemens AG 6SE7087-6QX70 (Version AD)
SIMOVERT MASTERDRIVES Compendium Motion Control 8.5-57
Error code
(hex)
Meaning MC error MC alarm Error text /
description
6320 parameter error F058
Parameter error in parameter
task
6380 parameter error F046 Parameter link error
6381
Parameter fault in follow-up
task
F053
Parameter error in following
task
6382
Parameter fault after factory
setting/init.
F059
Parameter error after factory
setting/init.
6383 Incorrect parameterization F061 Parameterization error
7000 additional modules F045 HW fault on option boards
7080 TB/CB initialization fault F080 TB/CB initialization error
7081 OptBoard Heartbeat-counter F081 Opt. board heartbeat counter
7082 Add. CB Initialization fault F085 Add. CB initialization error
7121 Motor blocked F015 Motor blocked
7180
Brake checkback
Brake still closed
A036
Brake checkback signal
"Brake still closed"
7181
Brake checkback
Brake still open
A037
Brake checkback signal
"Brake still open"
7182 Motor stall/lock A042 Mot. stalled/blocked
7183 A075
The values of the leakage or
rotor resistance measurement
vary widely
7184 Stands. Meas A078 Standstill measurement
7300 sensor F051 Encoder fault
7320 Actual Position value not O.K. A135 Actual position value not o.k.
7380 Encoder board initialisation fault F054
Encoder board initialization
error
7381 Encoder adjustment A018 Encoder adjustment
7382 Encoder data serial protocol A019 Encoder data serial protocol
7500 communication F082 TB/CB message failure
7580 communication warning 1 A083 CB alarm 1 (Subsect. 8.5.8.1)
7581 communication warning 2 A084 CB alarm 2 (Subsect. 8.5.8.1)
8130 communication warning 3 A085 CB alarm 3 (Subsect. 8.5.8.1)
8210 communication warning 4 A086 CB alarm 4 (Subsect. 8.5.8.1)
8480 Overspeed A033 Overspeed
8481 Setpoint/actual value deviation A034 Setpoint/actual deviation
8500 Following in error in stand still A140 Following error at standstill
8611 Following error in motion A141 Following error in motion
8680 In position - timer monitoring A142
Position reached - time
monitoring

Siemens simovert masterdrives Specifications

General

Brand	Siemens
Model	simovert masterdrives
Category	DC Drives
Language	English