Commissioning
4.11 Configuring brake control
Commissioning with Startdrive
300 Commissioning Manual, 11/2017, 6SL3097-4AA10-0BP1
4. Click "Status word". A mask with the same name opens.
Connect the signal sources for the following areas:
– Sequence control status word (r0899)
– Motor holding brake status word (r1229)
5. Click "Logic operations" in the "Brake control" mask.
The "Brake logic operations" dialog opens.
Figure 4-123 Extended brake control: Set logic operations
– Interconnect the signal sink for "OR operation" or for "AND operations".
– Click "OK" to confirm the settings and so close the dialog.
To Next Page
Loading...
