Siemens SINAMICS S200 - Page 345

133: Access method not de󹪝ned.
200: Below the valid values.
201: A
bove the valid values.
202: Cannot be accessed from the Basic Operator Panel (BOP).
203: Cannot be read from the Basic Operator Panel (BOP).
204: Write access not permitted.
Remedy: - Correct the parameterization in the commissioning tool and download the project again.
- Enter the correct v
alue in the speci󹪝ed parameter.
- Identify the parameter that restricts the limits of the speci󹪝ed parameter.
A01100 CU: Memory card withdrawn
Message class: General drive fault (19)
Message value: -
Component: Control Unit (CU)
Response: NONE
Acknowledgment: NONE
Cause: The memory card (non-volatile memory) was withdrawn during operation.
No
tice:
It is not permissible for t
he memory card to be withdrawn or inserted under voltage.
Remedy: - Switch o󹪜 the drive sys
tem.
- Re-insert the memory card that was withdrawn - This card must match the drive system.
- Switch on the drive system again.
F01105 CU: Insu󹪟cient memory
Message class: Er
ror in the parameterization / con󹪝guration / commissioning procedure (18)
Mes
sage value: %1
Component: Control Unit (CU)
Response: OFF1
Acknowledgment: POWER ON
Cause: The functionality on this Control Unit is too extensive (e.g. too many drives, functions, data sets, Technology Extensions,
bloc
ks, etc).
Fault v
alue (r0949, interpret decimal):
Only for internal Siemens troubleshooting.
Remedy: - Change the con󹪝guration on this Control Unit, e.g.
-- Use f
ewer axes
-- Reduce the number of con󹪝gurable functions
-- Use fewer data sets
-- Reduce Technology Extensions and blocks
- Use an additional Control Unit.
F01107 CU: Save to memory card unsuccessful
Message class: Hardware/software error (1)
Message value: %1
Component: Control Unit (CU)
Response: NONE
Acknowledgment: IMMEDIATELY
System messages
11.3Faults and alarms
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 343