Siemens SINAMICS S200 - Page 622

r0751.0...9 Analog inputs status word
S200 PTI Data type: Unsigned16 Visible in: Standar
d display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Parame
ter group: Analog inputs
Unit: -
Description: Display and binary signal source for the status of the analog inputs.
Bit array: Bit Signal name 1 signal 0 signal 
 00 Analog input AI0 wire breakage Yes No 
 01 Analog input AI1 wire breakage Yes No 
 08 Analog input AI0 no wire breakage Yes No 
 09 Analog input AI1 no wire breakage Yes No 
Note
AI: Analog In
put
r0752[0...1] Analog inputs actual input voltage/current
S200 PTI Data type: FloatingPoint32 Visible in: Standar
d display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Parame
ter group: Analog inputs
Unit: -
Description: Displays the actual input voltage in V when set as voltage input.
Displays the actual input current in mA when set as current input and with the load resistor switched in.
Index: [0] = AI0 (X132.19/20)
[1] = AI1 (X132.21/22)
Dependency: The type of analog input AIx (voltage or current input) is set using p0756.
See also: p0756
Note
AI: Analog In
put
p0753[0...1] Analog inputs smoothing time constant
S200 PTI Data type: FloatingPoint32 Visible in: Standar
d display 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Can be
changed in the operating
state:
Operation
Par
ameter group: Analog inputs
 Unit: ms
 Min:
0.0 [ms]
Max:
1000.0 [ms]
Factory setting:
0.0 [ms]
Description: Sets the smoothing time constant of the 1st order lowpass 󹪝lter for the analog in
puts.
Index: [0] = AI0 (X132.19/20)
[1] = AI1 (X132.21/22)
Note
AI: Analog Input
Appendix
A.3Parameters
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
620 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA