Siemens SINAMICS S200 - Page 714

 Min:
0.0 [rpm]
Max:
100.0 [rpm]
Factory setting:
10.0 [rpm]
Description: Sets the threshold for triggering the output signal SPDR.
p29101 Protective speed limit source selection
S200 PTI Data type: Integer16 Visible in: Extended displa
y 
Read permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Can be
changed in the operating
state:
Ready for oper
ation
Parameter group: Speed limiting, Technology Extensions
 Unit: -
 Min:
0
Max:
2
Factory setting:
0
Description: Selects a protective speed limit source.
0: Inhibit protective speed limit.
1: Se
t protective speed limit with the 󹪝xed value in p29102
2: Set protective speed limit with analog input 0.
Value: 0: PSL disable
 1: PSL 󹪝x
ed speed
 2: PSL AI speed
p29102[0...1] Positiv
e/negative protective speed limit 󹪝xed value
S200 PTI Data type: FloatingPoint32 Visible in: Extended display 
R
ead permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Can be
changed in the operating
state:
Operation
Par
ameter group: Speed limiting, Technology Extensions
 Unit: rpm
 Min:
0.00 [rpm]
Max:
210000.00 [rpm]
Factory setting:
500.00 [rpm]
Description: Sets the protective speed limit 󹪝xed value in positive/negative direction.
p29102[0]: protective speed limit 󹪝xed value in positive direction
p29102[1]: protective speed limit 󹪝xed value in negative direction
c29103[0...1] Protective speed limit
S200 PTI Data type: FloatingPoint32 Visible in: Extended display 
R
ead permission: Read drive data or acknowledge messages
Write permission: Edit device con󹪝gur
ation or drive applications
Parame
ter group: Technology Extensions
Unit: -
Description: AI channel for protective speed limit
Appendix
A.3Parameters
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
712 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA