Siemens SINAMICS S200 - Page 737

A.4.1 Assembling connectors on the converter side
A.4.1.1 Assembling the cable lugs
Ov
erview
This section o󹪜ers general assembly instructions for cable lugs and is applicable to the following
cables:
• Mains supply cable
• 24 V DC power supply cable
• Motor holding brake cable
• Motor power cable
• External braking resistor cable
• STO connection cable
Requirement
You have prepared appropriate tools, raw cables, and cable lugs.
Procedure
1. Remove the outer sheath of the cable.
2. Remove the insulation from the conductor. For more information about stripping length, see
Section "Cables and connectors (Page124)".
E
D
DE!PP
3. Insert the stripped end into the cable end sleeve.
4. Crimp the cable end sleeve.
Appendix
A.4Assembling cables
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 735