A.4.2 Assembling connectors on the motor side
A.4.2.1 Assembling the h
ybrid plug for 1FL2 motors, shaft heights 20, 30, and 40
Overview
The Siemens hybrid plug is used for connecting the converter to the motor and the encoder in
the motor. It consists of the following components:
① Cap ⑧ Signal unit case
② Clamp ⑨ Power unit case
③ Gasket ⑩ Hybrid power contact
④ M2 screw ⑪ Hybrid brake contact
⑤ Seal case ⑫ Sealing ring
⑥ Housing ⑬ Shield holding plate
⑦ Hybrid signal contact
FigureA-3 Hybrid plug overview
Appendix
A.4Assembling cables
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
740 Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA
To Next Page
Loading...
