Siemens SINAMICS S200 - Page 741

Procedure





5HPRYHWKHRXWHUVKHDWKRIWKHFDEOH
)ROGWKHFDEOHVKLHOGEDFNZDUGRYHUWKHFDEOHVKHDWK
DQGUHPRYHWKHLQVXODWLRQIURPWKHZLUHVE\PP
6OLGHWKHKHDWVKULQNDEOHWXEHVRQWRWKHZLUHV6ROGHUWKHZLUHVWRWKHFRQQHFWRU
:HOGLQJJXQ
&RYHUWKHSLQVZLWKKHDWVKULQNDEOHWXEHVDQG
ZUDSWKHIROGHGFDEOHVKLHOGZLWKDOXPLQXP
IRLOWDSH
$OXPLQXPIRLO
*URXQGSODWH
7LJKWHQLQJWRUTXH
1P
,QVWDOOWKHJURXQGSODWH
,QVWDOOWKHKRXVLQJ
7LJKWHQLQJWRUTXH
1P
PP
PP
PP
FigureA-2 Assembling the setpoint cable
Note
For better
EMC performance, Siemens recommends that you solder the cable shield to the metal
housing of the connector.
Appendix
A.4Assembling cables
SINAMICS S200 pulse train servo drive system with SIMOTICS S-1FL2
Operating Instructions, 11/2023, FW V6.3, A5E51646767B AA 739