3. In order to check which software version contains the tgz file, first select the tgz file, then
press "Show version".
The following information is output:
Figure 3-14 Version information
4. Select the appropriate tgz file and confirm with "Ok".
A message is output after the update has been successfully completed.
Completion
The system must be restarted in order that the new data become effective.
See also
The procedure for "Update system software from network drive" is essentially the same. In
addition, you connect to a network drive: This is how you connect to a network drive
(Page 67)
For a complete backup of the system: This is how you install a complete system backup
(Page 78)
Service and diagnostics
3.5 Updating the software
NCU operating system
88 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
