Configuring the system
2.4 Configuring the SITOP UPS module for use with the PCU Base Software
PCU-Basesoftware (IM8)
Commissioning Manual, 02/2014, 6FC5397-1DP40-4BA0
65
Proceed as follows to configure the SITOP software for use with the PCU base software:
1. Call the settings of the SITOP software, for example, by right-clicking the SITOP UPS
icon in the Windows information area and then selecting "Configuration".
The "SITOP DC UPS Configuration" dialog box opens.
2. In the "General" tab, select "UPS" in the drop-down list at "Serial interface".
To Next Page
Loading...
Need help?
General
