● Address type
Information about the configuration of the network adapter in the configuration file
"basesys.ini":
– DHCP: DHCP is active for this network adapter.
The information behind the hyphen "-" specifies the DHCP mode of operation:
off
- DHCP is deactivated for this adapter
Client
- a DHCP client that receives an IP address and further data from a server, is
running on the interface
Server
- the NCU provides a DHCP server on this interface that supplies clients on this
network with IPs
Synced Server
- a protocol is active with which several NCUs synchronize with each
other. This ensures that always only one of these NCUs functions as DHCP server and,
for example, no double IP addresses
are assigned.
If a network adapter operates as "Synced Server", the "State of sync. DHCP server" line
displays additional information.
If no changes have been made for the network adapters in the configuration file, then
"Default" is also output.
– Manual
The settings IP address, subnet mask, DNS server 1, DNS server 2 and gateway are
configured in the "basesys.ini".
Note:
In the "Change" mode, either "Manual" or "DHCP" can be selected (only for company
network, X130).
● IP address assigned
Current IP address of the network adapter.
● Subnet mask assigned
● DHCP server
IP address of the network adapter (for address type "DHCP").
● State, DHCP server
State of the synch. DHCP server:
– Active (actual NCU is active in the group of all NCUs in the "Synced Server" mode and
transfers the IP addresses);
– Standby (NCU is not active, if the active server fails, this NCU could take over the task
of the server).
● Mode, DHCP synchron.
Priority of the synch. DHCP server:
Low, High, Master
● DNS server 1, DNS server 2
Domain Name Server
● Gateway
● Note
All information that is not available is marked in the relevant table line with a hyphen "-".
Configuring the network
17.6 Station-related network diagnostics
SINUMERIK Operate (IM9)
394 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
