The available working area depends on the screen layout being used.
Width
This parameter defines the width of the window for the Windows application, measured in
pixels from the window origin according to parameter x.
Height
This parameter defines the height of the window for the Windows application, measured in
pixels from the window origin according to parameter y.
nDelayInitComplete
As soon as the window of a Windows application has been initiated, the information is sent to
the System Manager. The Windows application can then be selected using the System
Manager. This information can be delayed using the nDelayInitComplete parameter. The
unit is specified in milliseconds.
A delay is necessary, for example, if the Windows application must carry out other actions
while generating its window. If the window is activated too soon by the system manager, display
errors will occur in the Window.
Example
After creating its window, the Windows application "app.exe" reads additional status data from
a database. The window of the Windows application may only be displayed after all status data
has been read. This read operation should take approximately one second. The following
parameter assignment is possible:
[app]
nDelayInitComplete = 2000
fSearchOnlyForTaskWindow
This parameter specifies whether the window specified in the file "systemconfiguration.ini"
using ClassName/WindowName belongs to the task that is also specified there.
The following values can be used:
fSearchOnlyForTaskWindow
= 0
The window does not belong to the specified task.
= 1
The window belongs to the specified task.
When searching, not only are the windows of the task configured in "systemconfiguration.ini"
taken into account, but all of the windows that exist in the system at the time of the search.
Example
The Windows application comprises more than one process, e.g. a "startup.exe" and a
"user.exe". In the "systemconfiguration.ini" file, only "startup.exe" is entered, from which
"user.exe" is started. The application window belongs to "user.exe" and is therefore not found
when searching is restricted to the windows of "startup.exe".
SINUMERIK Operate on PC/PCU
23.2 Parameterizing the OEMFrame application
SINUMERIK Operate (IM9)
670 Commissioning Manual, 12/2017, 6FC5397-1DP40-6BA1
To Next Page
Loading...
Need help?
General
