•
Open the User-defined signals folder and add an SPS indication to the user-defined function block.
•
Open the information routing.
•
Route the SPS indication to a binary input by selecting the routing option H. The SPS signal is thereby
routed as active with voltage.
•
Move the menu bar from left to right and route the SPS indication to the recorder as desired.
[ScTrigDevInd-010715, 1, en_US]
Figure 7-52 Procedure: Trigger on SPS Indication
Fault Recorder
7.3 Function Description Analog and Binary Triggers
270 SIPROTEC 5, Fault Recorder, Manual
C53000-G5040-C018-5, Edition 11.2017
To Next Page
Loading...
