Siemens SIRIUS ACT 3SU1 - 3 SU10 Devices for Use on 4-Slot Holder; Coordinate Switches

3SU10 pushbuttons and indicator lights
5.2 3SU10 devices for use on 4-slot holder
SIRIUS ACT 3SU1 pushbuttons and signaling devices
104 System Manual, 08/2018, A5E03457306020A/RS-AK/010
5.2
3SU10 devices for use on 4-slot holder
5.2.1
Coordinate switches
Coordinate switches are used to temporarily or permanently select up to 4 positions. They
are operated by a vertical and horizontal movement using several fingers. Only one position
on the holder is actuated in each case. The coordinate switch is suitable for simple
navigation tasks thanks to its 4 selectable directions.
Coordinate switches are available in different variants according to the following features:
● Switch positions
● Collar and front ring material
● Locking (in the middle position)
A holder for 4 modules (3SU15.0-0BA10-0AA0) is required to install any of the devices listed
below. You will find additional information on this in Chapters "Holders
(Page 213)","Mounting (Page 109)" and "Equipping with contact modules without
EMERGENCY STOP (Page 177)".
Without mechanical interlock
2 switch positions 4 switch positions
Collar / Front ring
material
Operating
principle
Direction of
actuation
Article number
Plastic / Plastic
Momentary
contact
Horizontal
3SU1000-7AC10-0AA0
3SU1000-7AF10-0AA0
Vertical 3SU1000-7AD10-0AA0
Latching
Horizontal
3SU1000-7AA10-0AA0
3SU1000-7AE10-0AA0
Vertical 3SU1000-7AB10-0AA0
Plastic / Metal, matte
Momentary
contact
Horizontal
3SU1030-7AC10-0AA0
3SU1030-7AF10-0AA0
Vertical 3SU1030-7AD10-0AA0
Latching
Horizontal
3SU1030-7AA10-0AA0
3SU1030-7AE10-0AA0
Vertical
3SU1030-7AB10-0AA0
Metal / Metal
Momentary
contact
Horizontal
3SU1050-7AC88-0AA0
3SU1050-7AF88-0AA0
Vertical 3SU1050-7AD88-0AA0
Latching
Horizontal
3SU1050-7AA88-0AA0
3SU1050-7AE88-0AA0
Vertical
3SU1050-7AB88-0AA0