Siemens SIRIUS ACT 3SU1 - Enclosure Without Recess for Labeling Plate

3SU19 accessories
13.13 Use of accessories for the enclosure
SIRIUS ACT 3SU1 pushbuttons and signaling devices
438 System Manual, 08/2018, A5E03457306020A/RS-AK/010
13.13.2
Enclosure without recess for labeling plate
Please note the following instructions for using the accessories:
Enclosure without recess for labeling plate (except enclosures with protective collar)
Accessories
Suitable for front mounting
Suitable for base mounting
Label holder (Page 388)
✓
—
Square single frame (Page 432)
✓
—
EMERGENCY STOP backing plate
(Page 366)
— —
Protective collar for EMERGENCY
STOP (Page 402)
✓ —
360° protective collar (Page 402)
✓
—
Protective collar for pushbutton
(Page 402)
✓ —
Protective collar for mushroom
pushbutton (Page 402)
✓ —
Sun collar (Page 402)
✓
✓
Protective collar 360° for pushbutton
and short selector (Page 402)
✓ —
Locking device (Page 406)
—
—
Padlock (Page 402)
✓
—
Protective caps (Page 392)
✓
—
Dust cap for key-operated switches
(Page 392)
✓ ✓
Sealable cap (Page 391)
✓
—
Labeling plates for enclosures with
EMERGENCY STOP (Page 379)
✓ —
Sealing plug (Page 417)
—
—
Enclosure adapters for mounting 2-pole
contact modules (Page 427)
✓ —
Enclosure mounting adapters for strut
profiles (Page 428)
✓ ✓
Enclosure cover monitoring (Page 428)
—
✓
When using an accessory that is mounted between the actuating element and the front plate,
the maximum thickness of the front plate is reduced by the corresponding value of the
accessory.