Siemens SIRIUS ACT 3SU1 - Enclosure Mounting Adapter; Enclosure Cover Monitoring

3SU19 accessories
13.10 Accessories for enclosures
SIRIUS ACT 3SU1 pushbuttons and signaling devices
428 System Manual, 08/2018, A5E03457306020A/RS-AK/010
13.10.6
Enclosure mounting adapter
The enclosure mounting adapter allows you to mount a SIRIUS ACT enclosure on a strut
profile. For SIRIUS ACT enclosures with 2 command points or more, the adapter must be
split along the perforation in the middle. Sliding blocks for a 10 mm groove are included in
the scope of supply. To secure the enclosure, you need 4 screws with the following
dimensions: min. M4x12 mm up to max. M4x15 mm.
Description
Material
Article number
Enclosure mounting
adapter
for strut
profiles
Metal 3SU1950-0JE80-0AA0
13.10.7
Enclosure cover monitoring
Enclosure cover monitoring
Siemens Industry Mall
(http://mall.industry.siemens.com/mall/en/WW/Catalog/Products/10221536
)
Enclosure cover monitoring is fitted at the intermediate position of the command points. The
plunger is screwed onto the enclosure cover (tightening torque: plastic: 0.6 ... 0.8 Nm, metal:
0.8 ... 1.0 Nm). The module attachment is snapped into the intermediate position on the
enclosure base and fitted with 1 NO (normally-open) contact module (3SU1400-2AA10-
.BA0). The entire circuit is routed via this contact module. When the enclosure has been
correctly screwed together, the circuit closes and the controlled device can be operated.
Note that the enclosure cover monitoring cannot be used with the raised enclosures with one
command point (3SU18.1-1AA00-1AA1).
For further information about installing the enclosure cover monitoring system, refer to
Chapter "Installation steps for enclosure cover monitoring (Page 429)".
Note also the information in Chapter "Use of accessories for the enclosure (Page 437)".
Description
Material
Article number
Enclosure cover monitoring
(module with extension plunger)
Plastic 3SU1900-0HM10-0AA0