Siemens SIRIUS ACT 3SU1 - Installing IO-Link Electronic Modules for Front Plate Mounting

IO-Link 3SU14
12.3 Electronic modules for IO-Link
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
357
Mounting possibilities on 4-slot holder
3SU10 devices for 4-slot holder
Holder position
1
Holder position
2
Holder position
4
Holder position
3
Coordinate switches, top/bottom
x
-
-
x
Coordinate switches, right/left - x x -
Coordinate switches, right/left/top/bottom
-
-
-
-
Selector switches, 4 switch positions
-
-
-
-
12.3.5.2
Installing IO-Link electronic modules for front plate mounting
Procedure
1. Insert the actuating or signaling element from the front into the opening of the front plate.
2. Fit the holder from behind. Ensure secure latching here.
3. Tighten the screw on the holder (tightening torque 1.0 to 1.2 Nm).
4. Snap the IO-Link electronic module for front plate mounting from behind onto the holder.
④ / ⑤
Ensure the IO-Link electronic module for front plate mounting is securely snapped into
place.