EasyManua.ls Logo

Siemens SIRIUS ACT 3SU1 - 8.1.17 Electronic modules for ID key-operated switches

Siemens SIRIUS ACT 3SU1
610 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3SU14 modules
8.1 Overview
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
195
8.1.17
Electronic modules for ID key-operated switches
The electronic modules for ID key-operated switches are designed for use with the ID key-
operated switch. The electronic modules for ID key-operated switches can be installed in a
3SU18.1-1AA00-1AA1 enclosure for one command point, or in a front plate using 3-slot
holders. The 3SU1400-1GD10-1AA0 electronics modules for ID key-operated switches can
be parameterized via IO-Link.
The version of electronic modules for ID key-operated switches with IO-Link
(3SU1400-1GD10-1AA0) satisfies the maximum emission limit values on the basis of the
following rules:
F
or the USA:
$15.201(a) devices under 490 kHz, where all emissions are at least 40 dB under the limit
value according to $15.209.
For Canada:
RSS-310, Edition 4, July 2015 Chapter 3.7
Transmitters with a basic emission under 490 kHz and for which it has been certified that
all of the emissions are at least 40 dB under the general field intensity limits listed i
n
R
SS-Gen must correspond to the general provisions of RSS-310 and the applicabl
e
pr
ovisions of RSS-Gen.
This device corresponds to the RSS-310 of Industry Canada. Its operation is subject t
o
t
he condition that this device must not cause any radio interference and is protected fro
m
int
erference that can lead to undesired operation of the device.
For the installation you must use the plastic holder (3SU1500-0AA10-0AA0).
For further information on the devices, refer to Chapters "ID key-operated switches
(Page 88)", "ID keys (Page 415)" and "Technical data (Page 439)".
You can find information on using the electronic modules for ID key-operated switches for
IO-Link in Chapter "IO-Link 3SU14 (Page 303)".
Article numbers
Siemens Industry Mall
(http://mall.industry.siemens.com/mall/en/WW/Catalog/Products/10221530
)
IO-Link protocol
supported
Power supply via
IO-Link master
IO-Link transfer
rate
Article number
No
---
---
3SU1400-1GC10-1AA0
Yes Yes COM2
(38.4 kBaud)
3SU1400-1GD10-1AA0

Table of Contents

Related product manuals