Siemens SIRIUS ACT 3SU1 - Mounting and Disassembling AS-Interface Modules (3 SU1400-1 E.10-6 AA0)

AS-Interface 3SU14
11.7 Mounting and disassembling AS-Interface modules (3SU1400-1E.10-6AA0)
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
265
11.7
Mounting and disassembling AS-Interface modules (3SU1400-
1E.10-6AA0)
Mounting
Installing AS-Interface modules for front plate mounting (3SU1400-1E.10-6AA0)
Procedure
1. Insert the actuating or signaling element from the front into the opening of the front plate.
2. Fit the holder from behind. Ensure secure latching here.
3. Tighten the screw on the holder (tightening torque 1.0 to 1.2 Nm).
4. Snap the AS-i module for front plate mounting from behind onto the holder.
Ensure the AS-i module for front plate mounting is securely snapped into place.
Disassembly
The AS-Interface modules for front plate mounting (3SU1400-1E.10-6AA0) are
disassembled in the same way as the 3SU14 contact and LED modules.
Procedure:
1. Insert a screwdriver into the opening of the latches (broad snap hook) of the module.
2. Press the screwdriver down to open the latches of the modules.
3. Remove the module.
You will also find further information in Chapter "Disassembling modules (Page 201)".