Siemens SIRIUS ACT 3SU1 - Holders with Modules

3SU15 holders
9.2 Holders with modules
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
217
9.2
Holders with modules
Overview of holders with contact module
These variants are preassembled. You need only snap them onto the actuator, tighten the
fastening screws and connect the cables.
You can find information about the contact modules used in Chapter "Contact modules for
front plate mounting (Page 171)".
Holder position 1
Holder position 2
Holder position 3
Article number
Plastic
Siemens Industry Mall (http://mall.industry.siemens.com/mall/en/ww/Catalog/Products/10221517)
3SU1400-1AA10-1BA0
—
—
3SU1500-1AA10-1BA0
3SU1400-1AA10-1CA0
—
—
3SU1500-1AA10-1CA0
3SU1400-1AA10-1BA0 — 3SU1400-1AA10-1BA0 3SU1500-1AA10-1NA0
3SU1400-1AA10-1CA0
—
3SU1400-1AA10-1CA0
3SU1500-1AA10-1PA0
Metal
Siemens Industry Mall (http://mall.industry.siemens.com/mall/en/ww/Catalog/Products/10221517)
3SU1400-1AA10-1BA0
—
—
3SU1550-1AA10-1BA0
3SU1400-1AA10-1CA0
—
—
3SU1550-1AA10-1CA0
3SU1400-1AA10-1BA0
—
3SU1400-1AA10-1BA0
3SU1550-1AA10-1NA0
3SU1400-1AA10-1CA0
—
3SU1400-1AA10-1CA0
3SU1550-1AA10-1PA0
3SU1400
-1AA10-1BA0: Contact module 1NO normally open contact
3SU1400-1AA10-1CA0: Contact module 1NC normally closed contact