Siemens SIRIUS ACT 3SU1 - Parameters

IO-Link 3SU14
12.2 Electronic modules for ID key-operated switches
SIRIUS ACT 3SU1 pushbuttons and signaling devices
322 System Manual, 08/2018, A5E03457306020A/RS-AK/010
12.2.5
Parameters
12.2.5.1
Parameters
The following parameters can be set:
● Incremental switching mode
● Switch position memory
● Switch position retentive memory
● Individually codable ID keys only
● Switch position delay
● Select memory range
● Restore Factory Setting
● Add new individual ID key
● Deactivation of the switch-off function (firmware 2.0.0; included in the device as of
product version E03)
● Delete individually codable ID key
● Parameter (write) Access Lock (parameters for IO-Link devices according to IO-Link
communication specification V1.1)
● Data Storage Lock (parameters for IO-Link devices according to IO-Link communication
specification V1.1)
The "Parameter (write) Access Lock" and "Data Storage Lock" parameters can be set in the
"Port Configuration Tool S7-PCT"
V3.0 or higher.
Notes on parameter assignment
Transfer of the parameters with the "Parameterserver" function if IO-Link masters and
IO-Link devices according to the IO-Link communication specification V1.1 are available:
1. The "Parameter server" function backs up the parameter data from the IO-Link devices.
2. Replace the IO-Link device.
3. The parameter data is automatically written back to the new IO-Link device on system
startup.