Siemens SIRIUS ACT 3SU1 - Page 385

3SU19 accessories
13.2 Identification of command points
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
385
Labeling plates
The labeling plates can be inscribed with text and symbols not listed in the ordering data.
The following letter heights are used as standard for text inscriptions:
● Label size 12.5 mm × 27 mm: 3 lines with letter height 4 mm (1-line), 3.5 mm (2-line) or
2.5 mm (3-line)
● Label size 17.5 mm × 27 mm: 3 lines with letter height 4 mm (1- to 2-line) or 3 mm (3-line)
● Label size 27 mm × 27 mm: 5 lines with letter height 4 mm (1- to 5-line)
● Label size 22 mm × 22 mm: with letter height 4 mm (1- to 3-line)
Up to 11 characters per line are possible. The typeface used is Arial. Other letter heights and
typefaces are possible, but must be specified when ordering.
Examples for customized inscription of the insert labels
Figure 13-6 Two-line inscription in upper/lower case lettering (Q0Y)
Figure 13-7 Single-line inscription in upper case lettering (Q1Y)
Figure 13-8 Three-line inscription in lower case lettering (Q2Y)
Figure 13-9 Symbol number 5011 according to IEC 60417 (Q3Y)
Figure 13-10 Any symbol according to order form supplement (Q9Y)