3SU10 pushbuttons and indicator lights
5.1 3SU10 devices for use on 3-slot holder
SIRIUS ACT 3SU1 pushbuttons and signaling devices
System Manual, 08/2018, A5E03457306020A/RS-AK/010
93
Function of the LEDs in the ID key-operated switch
In the enclosure of the ID key-operated switch are 4 illuminated surfaces that can assume
the following states:
● Showing a green light: Indication of the current key position and the switched outputs.
● Flashing green: Indication of the temporary key position.
● Showing a yellow light: Indication of the associated authorization level (key position that
can be reached by turning the rotary knob).
● Flashing yellow (all 4 illuminated surfaces): Indication for the individually codable ID key
used that has not yet been configured.
● Showing a red light: Indicates that the relevant key position is higher than permissible for
the relevant authorization level. (This key position cannot be reached by turning the rotary
knob.) The indicator also shows a red light when there is no ID key plugged in.
● Flashing red (all 4 illuminated surfaces): When using a colored ID key with permanently
encoded authorization level (ID group 1 to 4), this indicates when the parameter
"Individually codable ID keys only" is enabled.
● Not illuminated: The electronic module is switched off.
To Next Page
Loading...
