Silca Triax Pro - Page 10

NOMENCLATURE OF SYSTEMS-LOCKS INSERTED IN MACHINE
Examples:
• The description “SIP22T5 (2T-8W)” used for a “Fiat®*” System/Lock is made up of a rst part (SIP22T5) which
is the Silca key blank used and a second part (2T) which is the number of grooves on the key and (8W) the
number of its blades.
• The description “8 (4 +4P) 1-200” used for a “Kaba®*” System/Lock is made up of a rst part (8) which is the
name of the system, a second part (4+4P) which is the number of pins on the 2 key-cutting axes and a third
part which gives the indirect cutting code (1-200).
A
Numero di assi o le di pistoncini/perni
L
Indica che la la principale di pistoncini è sul lato Sinistro della chiave
R
Indica che la la principale di pistoncini è sul lato Destro della chiave
P
Numero di pistoncini/perni per ogni asse/la
T
Numero di tracce di tipo Laser
W
Numero di lamelle
pf
Esempio “pf 121” indica “prolo originale 121”
(*) are registered trade marks
GRAPHICS ON MACHINE DISPLAY
SSN
(e.g. 16) Silca Serial Number
(e.g. 8-8) Maximum number of cutting positions for each axis on the key
8(4+4P) SSN description
SSN with protected code table only
SSN with code table enabled
1-200 Indirect cutting codes
KA1 Silca key blank proposed for duplication
KABA Manufacturer of system and/or applications involved
Silca SSN
SSN protected by password (Locked).
SSN enabled (Released)
An engraving template is associated to the system in question
User-created series
UTP (Unlimited Token Plan)
Table 2
Operating manual TRIAX PRO
Copyright Silca 2016
4