Silca Triax Pro - Page 9

TERMINOLOGY
For those who have no experience of keys and key-cutting, below is an illustration of the most frequently used
terms:
KEY TERMINOLOGY (general)
6
7
1
2
3
4
5
7
8
Fig. 1 Fig. 2
1. Head
2. Neck
3. Stop
4. Blade
5. Tip
6. Back
7. Cuts
8. Engraving area
KEY TERMINOLOGY (software)
SSN*
* Silca Serial Number
SSN*
* Silca Serial Number
Fig. 3 Fig. 4
A
C
B
D
Side A (1st at side)
Side B (1st back)
Side C (2nd at side)
Side D (2nd back)
ATTENTION: anodised aluminium dimple/laser keys, plastic keys or any other key without electrical
conductivity CANNOT BE decoded! For these types of keys digit the cuts directly or enter the indirect
code if the SSN in use allows it.
Operating manual TRIAX PRO
Copyright Silca 2016
3