C4 User Manual
Page 184 ©2021 Smartrise Engineering, Inc. All Rights Reserved October 25, 2021
3. From the NUDGE – BUZZER ONLY menu, scroll and select On if the buzzer sounds when
nudging.
Figure 331: NUDGE – BUZZER ONLY Menu
4. Scroll right and press Save.
16.22 Opening Time
The opening time is the time for a door to go from fully closed to fully open. This allows the
controller to estimate door opening time for use during preflight operation.
The following procedure describes how to set the time to fully open the doors.
1. Navigate to MAIN MENU | SETUP | DOOR SETUP. See Figure 55.
2. From the DOORS menu, scroll and select Opening Time.
Figure 332: DOORS Menu – Opening Time
3. From the OPENING TIME menu, set the time for the doors to fully open.
Figure 333: OPENING TIME Menu
4. Scroll right and press Save.
16.23 Check Time
The check time is the configured amount of time that the doors need to be considered safe
before the car is allowed to run on automatic operation.
The following procedure describes how to set the check time.
1. Navigate to MAIN MENU | SETUP | DOOR SETUP. See Figure 55.
To Next Page
Loading...
Need help?
General
