C4 User Manual
Page 354 ©2021 Smartrise Engineering, Inc. All Rights Reserved October 25, 2021
3. From the TERMINAL TO TERMINAL menu, scroll and select if the front or rear doors
open while running terminal to terminal.
Figure 722: TERMINAL TO TERMINAL Menu – Front or Rear
4. From the TERMINAL TO TERMINAL (FRONT or REAR) menu, scroll and select if enabling
the car to stop at the other terminal with the doors that only open from the front or
rear.
Figure 723: TERMINAL TO TERMINAL Menu
5. Scroll right and press Save.
40.12.3 Floor to Floor
The floor to floor allows the car to stop at each floor that have doors that open from the front
or doors that open from the rear.
The following procedure describes how to set the car to stop at each floor.
1. Navigate to MAIN MENU | DEBUG | DEBUGRUNS. See Figure 67.
2. From the DEBUGRUNS menu, scroll and select Floor To Floor.
Figure 724: DEBUGRUNS Menu – Floor To Floor
3. From the FLOOR TO FLOOR menu, scroll and select if checking front or rear doors.
Figure 725: FLOOR TO FLOOR Menu – Front or Rear