C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 217
Disables passing chime when active.
At a central control console, a distress and light buzzer
is provided for each elevator and an acknowledge
button common to all elevators. Pressing the distress
alarm button, triggering the emergency stop switch, if
a dispatched car remains at a landing for >30 seconds,
or if the electrical safety circuit is open, will turn on the
distress light and pulse the distress buzzer. The Distress
light will remain lit until the acknowledge button is
pressed.
At a central control console, a distress and light buzzer
is provided for each elevator and an acknowledge
button common to all elevators. Pressing the distress
alarm button, triggering the emergency stop switch, if
a dispatched car remains at a landing for >30 seconds,
or if the electrical safety circuit is open, will turn on the
distress light and pulse the distress buzzer. The Distress
light will remain lit until the acknowledge button is
pressed.
Holds car on EMS Phase 2 operation after activation of
EMS Phase 1 operation.
Bypasses car call security on all floors.
Enables all car call front buttons, bypassing car call
security on all front car call buttons.
Enables all car call rear buttons, bypassing car call
security on all rear car call buttons.
Bypasses hall call security on all landings.
Causes the car to park at the top floor when idle.
Causes the car to park at the lobby floor when idle.
Causes the car to park at the bottom floor when idle.
Puts car on swing operation, removing the car from
regular group calls and allowing it to take swing hall
calls.
Puts car on independent service operation.
Analog load weigher signal indicating weight below
configured threshold. Used for anti-nuisance features.
Puts the car on marshal mode operation.
Puts car on Sabbath operation where car will
automatically move to configured floors and cycle
doors, without user intervention.
Puts the car on wander guard operation.
To Next Page
Loading...
