C4 User Manual
Page 232 ©2021 Smartrise Engineering, Inc. All Rights Reserved October 25, 2021
To disable Marshal Mode, the key switch input needs to be off. This will cause the car to join
the group and resume normal operation.
To set the controller to Marshall Mode, see section 21.1 Adding an Input or Output.
25 Wander Guard
Wander Guard is a security setting for preventing an unauthorized person from using the
elevator. The car continues to run in normal operation but skips the floors set up for Wander
Guard. In case the car does stop at that floor, the car stays at that floor and the doors remain
open.
To set the controller to Wander Guard, see section 21.1 Adding an Input or Output.
To Next Page
Loading...
Need help?
General
