Smartrise C4

C4 User Manual
October 25, 2021 ©2021 Smartrise Engineering, Inc. All Rights Reserved Page 59
Menu
Description
Dir. Change Delay
Sets the time to delay car direction changes. Allows time
for passengers to enter their car calls. Units are in 1
second counts.
Default
Parameter default options
Parking
GUI Parking
Enable GUI parking
Parking Timer (1 sec)
Sets the time it takes before an idle car is parked. If set to
zero, parking is disabled.
Parking Floor
Floor the car parks at
Parking Door Open
Enables parking with doors open
OOS
Disable OOS
Disables the controller from going out of service due to
reoccurring faults
Hourly Fault Limit
Sets the number of faults allowed within a 1-hour window
before the car goes out of service. If the car goes out of
service, it remains out of service until the hour window
elapses.
Max Starts Per Minute
Specifies how many times the car may attempt to start a
run in automatic operation during a 1-minute window. If
the controller attempts additional runs, the car goes out
of service until the real-time clock increments to the next
minute. Set this parameter to zero to disable the feature.
Disable PI OOS
When set ON, OOS does not flash on the PI when the car
is out of group
Default
Default Floors
Default learned floor values
Default S-Curve
Default S-curve values
Default Run Timers
Default Run Timer values
Default I/O
Default inputs and outputs
Default Factory
Restore all parameters to factory settings
Default FRAM
Set ON to default the FRAM chip. This option is self-
resetting. This clears fault/alarm logs, latched faults,
emergency bits and run counter.
Default Other
Defaults all miscellaneous values
NTS
NTS Pos
Calculated NTS positions
NTS Vel
Calculated NTS velocities
NTS Pos
NTS Pos 1
Calculated NTS Position 1 – Normal Profile
NTS Pos 3
Calculated NTS Position 3 – Emergency Power Profile
NTS Pos 4
Calculated NTS Position 4 – Short Profile
NTS VEL
NTS Vel 1
Calculated NTS Velocity 1 – Normal Profile