11
Updating from Firmware 2.x to 3.x
3 Updating from Firmware 2.x to 3.x
The following note is for the Solar-Log 200, 500 and 1000 models when updating to firmware version 3.x.
In order to update to 3.x, the Solar-Log™ must at least be running firmware version 2.x. The latest firmware
can be downloaded from our website:
http://www.solar-log.com/de/service-support/firmware.html.
Note!
After installing firmware 3.x, it is no longer possible to downgrade to the previous ver-
sions. It is not possible to install older firmware versions.
The following changes occur when upgrading to 3.x:
•
The data transfer function is no longer available.
•
The Smart Energy section has been completely revised. If the function External Switch (only Solar-
Log 1000) is used, this part needs to be reconfigured after the update.
•
The settings and function of the power management have to be checked and, if need be, reconfig-
ured.
•
With the new modern web interface, old web browsers might sometimes cause problems with the
functionality. We recommend using the current version of Mozilla's Firefox, Google's Chrome, Mi-
crosoft Edge or Microsoft's Internet Explorer.
As part of the update, the Solar-Log™ has a data reformatting process running in the background. This
process starts once the update is finished. This process could last several hours and the Solar-Log™ will
operate and react slower until the update finishes.
To Next Page
Loading...
Need help?
General
