Solar-Log 2000 Installation Manual

68
Installation
14.3.1 Carrying out the initial set up of the Solar-Log 1200
The initial configuration of Solar-Log 1200 is made via a Web browser.
Procedure:
•
Enter the address http://solar-log in the address bar of the web browser.
•
A selection of display languages is displayed.
•
Select the desired Display Language.
•
The welcome screen then appears.
•
In the navigation bar at the top, click on Configuration.
•
The following menus have to be configured:
Internet (Chapter 17 on page 87)
Network (Chapter 16.1 on page 79)
Device (Chapter 18 on page 91)
Plant (Chapter 19 on page 104) and
System (Chapter 22 on page 124)
14.4 Initial installation Solar-Log 1000 and 2000
The initial configuration of Solar-Log
1200
is made via a Web browser. All of the device connections need to
be established and it is best to connect the Solar-Log 2000 to an Internet router.
All settings made at the initial startup can be changed at a later time.
14.4.1 Carrying out the initial set up of the Solar-Log 2000
The initial configuration of Solar-Log 2000 is made via a Web browser.
Procedure:
•
Enter the address http://solar-log in the address bar of the web browser.
•
A selection of display languages is displayed.
•
Select the desired Display Language.
•
The welcome screen then appears.
•
In the navigation bar at the top, click on Configuration.
•
The following menus have to be configured:
Internet (Chapter 17 on page 87)
Network (Chapter 16.1 on page 79)
Device (Chapter 18 on page 91)
Plant (Chapter 19 on page 104) and
System (Chapter 22 on page 124)

Solar-Log 2000 Specifications

General

Device Type	Data Logger
Max Inverters	100
Power Supply	24 V DC
Remote Monitoring	Yes
Ethernet interface	Yes
Communication Interfaces	RS485, Ethernet
Protocols	Modbus
Data Storage	Internal