191
Faults
28.2.2 Fault messages time
These fault messages are displayed on the LCD display
Fault messages
Time
Error code Message Possible cause or remedy
1 No time/date set Set the time and date or use the automatic time
synchronization function
TM Just like error 1
The names have been changed with Firmware
3.0.2.
28.2.3 Fault messages WiFi
These fault messages are shown in the LCD display and also in the Status box under Configuration | Net-
work | WiFi.
Fault messages WiFi
Error code Message Possible cause/remedy
10 Initialization error
11 Incorrect WiFi congura-
tion
Please check if all of the required param-
eters were congured.
12 Error while initializing the
wireless LAN module
Potential hardware failure. Contact tech-
nical support
20 Error while connecting The signal is too weak. Other network
signals are interfering with the connec-
tion.
21 No access point found The access point is turned off or not
available. The SSID was entered incor-
rectly.
30 Authentication failure The network key entered is incorrect.
The encryption type entered is wrong.
99 Unknown error An unexpected error occurred. If this
error continues to occur, contact our
technical support.
To Next Page
Loading...
Need help?
General
