98
Configuring connected devices
18.4.6 Configuring IDM Heat Pumps
IDM heat pumps can be selected from the drop-down menu from the Device Configuration menu and con-
figured accordingly.
Procedure:
•
Select the IDM heat pumps from the drop-down menu under devices.
•
Select the operating mode from the meter configuration menu.
•
Configure the device.
•
SAVE the settings.
The following configuration options are available for the operating mode.
Operating modes:
•
Consumption meter mode:
• Group selection for PM control with self-consumption.
• Maximum AC power
• Name
•
Sub-consumption meter mode:
• Maximum AC power
• Name
Note!
The IDM heat pump is an intelligent appliance. The available reported surplus is reported
to the intelligent electrical appliances and can be consumed by them.
Starting with firmware version 3.5.x, the simultaneous connection of several intelligent
electrical appliances is supported.
To Next Page
Loading...
