112
Configuring Notifications
Save all
When using this button, all of the settings are saved for all of the detected devices.
Using the same settings for several or all of the devices is a good idea when these devices also have the
same status and error codes.
Configuration example
Status codes 0 to 8, 12 to 15 and 31 to 45 should result in an e-mail notification being sent, and status codes
16-31 for a relay signal. The fault codes 0 to 30 should result in a text messages (SMS) notification being
sent.
This results in the following configuration:
Fig.: Conguration example for ltering status and fault codes
Note!
This filter can also be used for status notifications from other devices such as meters and
sensors as an option to deactivate notifications.
20.3 Yield
Yield notifications can be configured in this tab.
Notifications per e-mail section
Procedure
Select the extent of the yield notification message in this section. The following selection options are avail-
able:
•
Deactivated
•
Yield overview short
•
Yield overview (all INV)
•
Yield overview (all INV & groups)
•
The Sending time can be entered in the text field.
It is recommended to select a sending time when the inverters are no longer feeding power.
•
Check the days on which the e-mails should be sent. E-mails are only sent on the days checked.
•
SAVE the settings.
Text message (SMS) notifications
Procedure
•
Activate the Text message (SMS) notification button.
•
The Sending time can be entered in the text field.
It is recommended to select a sending time when the inverters are no longer feeding power.
To Next Page
Loading...
