111
Configuring Notifications
Filter status and fault codes section
The default setting is that messages are sent for all fault codes. Custom limits to sending notifications can
be configured in this section.
The status and fault messages that do not have any influence on the inverter operation can be filtered out
with this function.
Procedure
•
Select the relevant code groups based on the list for status and fault codes.
•
Check the Active box.
•
Select whether the filter applies to status or fault messages.
•
Determine which codes are to trigger a notification with the From Code and To Code box.
•
Select whether the notifications should be sent by e-mail and/or text message (SMS) and/or sig-
naled via a relay.
•
By activating After X active readings, brief, temporary fault notifications can be filtered out.
Note!
A corresponding status or fault message is also sent from the inverters for very brief,
temporary faults. To filter out brief faults, the After X active readings function should be
set to at least 20. A measurement usually takes 15 seconds.
•
The Max. per day box defines how many notifications per day should be sent from this code range.
Note!
If the maximum number of notifications per day is defined too low, this can lead to im-
portant messages not being sent.
•
SAVE the settings.
In the Save menu, there are three different options:
•
SAVE
•
SAVE MULTIPLE
•
SAVE ALL
Save
When using this button, the settings for the device selected as the device are saved.
Save multiple
When using this button, a selection box appears from which other devices can be added by checking them.
To Next Page
Loading...
