Solar-Log 2000 Installation Manual

122
Editing Data
Resetting inverter configuration section
If the Device Detection needs to be started again, it is recommended to delete the previous inverter con-
figuration with this function.
Procedure
•
Click on RESET.
•
If you are sure that the inverter configuration should be deleted, click on Continue. Otherwise click
on Cancel.
•
The data and inverter configuration are deleted.
•
The Solar-Log™ reboots itself.
Restore factory settings section
This function restores the Solar-Log™ to its factory settings. All of the yield data and configuration is de-
leted.
Procedure
•
Click on RESET.
•
If you are sure that the data should be deleted, click on Continue. Otherwise click on Cancel.
•
The factory settings are being restored
•
The Solar-Log™ reboots itself.
Note!
The network settings remain when this function is used.
Note!
The reset button on the device has to be used to delete all of the settings, including
network settings, for Solar-Log™ devices without a display (Solar-Log 200, 250 and
300). The Solar-Log™ is then set to automatically receive its IP address from the router.
(DHCP)
=> only with router or switch.

Solar-Log 2000 Specifications

General

Device Type	Data Logger
Max Inverters	100
Power Supply	24 V DC
Remote Monitoring	Yes
Ethernet interface	Yes
Communication Interfaces	RS485, Ethernet
Protocols	Modbus
Data Storage	Internal