15 System Maintenance
Basic User Manual 145
A2: Check whether the power supply cable and video cable are securely connected.
Q3: The LCD monitor displays abnormal.
A3: Check whether you select the appropriate probe and a compatible exam type, or optimize imaging parameters
correctly. For details, refer to Chapter 6 Acquiring Images.
Q4: The measurement cannot be performed after pressing the
Calc
key on the control panel.
A4: Ensure you pressing the
Calc
key in the frozen mode.
If any of the above problems still exist, please contact the Customer Service Department of the manufacturer for
help.
15.4 Replacing the Fuse
Power off the system and disconnect the power cable from the socket before replacing the fuse.
Two fuses with specifications of 50CT-T3.15AH 250V are provided by the
manufacturer. You can also purchase the fuse with the same specications for
the fuse replacement.
You can replace the fuse under the instructions of the service personnel if the
fuse is blown.
If the fuse is blown again after a replacement, please stop using the system
immediately and contact customer service.
15.5 Equipment Disposal
You should dispose of the main unit, the probe, the biopsy bracket and other accessories in accordance with local
laws and regulations.
For the detailed disposal information, consult the manufacturer or the local distributor. The manufacturer is not
responsible for any system content or accessories that have been discarded improperly.
15.6 Customer Service
Only the service personnel of or authorized by the manufacturer can service the system. Any feedback or inquires
concerning our product or services should be directed to the following address.
Contact Address: 2F, 12th Building, Shenzhen Software Park Phase II, Keji Middle 2nd Road, Nanshan District,
Shenzhen, 518057, Guangdong, China
Tel: +86-755-26722890
E-mail: service@sonoscape.net
To Next Page
Loading...
Need help?
General
