Chapter 11 DME Operations
684
DME Special Effect Operations
To apply the Page Turn effect
With the Page Turn menu displayed, use the following procedure.
1
In the <Split Mode> group, select the split mode.
H&V: The image turns as it is split from the center into 4 parts: left, right,
upper, lower.
H: The image turns as it is split from the center into 2 parts: left, right.
V: The image turns as it is split from the center into 2 parts: upper, lower.
When nothing is selected (Off): There are no splits and the image turns
from the edge.
2
Press [Page Turn], then set the following parameters.
a) When split mode is H&V
b) When split mode is H
c) When split mode is V
d) When split mode is off
To set the input signal of the back page
1
In the <Back Video> group, select the signal input into the back page.
Self: Use the same signal as the front page.
Flat: Use a flat color.
Hue Rotation: Gradually vary the hue.
2nd Ch: Use the 2nd channel video signal.
To select “2nd Ch,” it is first necessary to select the second DME on
the keyer using DME.
2
Adjust the following parameters, according to the selected input signal.
• When Flat is selected
Knob Parameter Adjustment Setting values
1 Radius Radius of turn part 0.00 to 100.00
2 Offset Amount of turn –100.00 to +100.00
3 Angle Angle of turn
–0.250 to +0.000
a)
–0.250 to +0.250
b)
–0.500 to +0.000
c)
–8.000 to +8.000
d)
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Hue Hue 359.99 to 0.00
To Next Page
Loading...
