Chapter 11 DME Operations
685
DME Special Effect Operations
• When Hue Rotation is selected
Notes
When using a page turn effect with one channel, the following restrictions
apply.
In an MVE-8000 or MVE-8000A HD system, when the input is for example a
title, parts of the back page other than the title appear as black.
Roll settings
There are four modes: H&V, H, V, and Off. You can select the turn position,
the radius of the turned portion, the amount and angle of turning, and the input
video for the front and back pages.
To apply the Roll effect
Display the Roll menu.
The knobs in the Roll menu have the same functions as those in the Page Turn
menu.
For details about operation, see “Page Turn settings” (page 683).
Notes
When using a roll effect with one channel, the following restrictions apply.
In an MVE-8000 or MVE-8000A HD system, when the input is for example a
title, parts of the back page other than the title appear as black.
Cylinder settings
You can set the degree of winding onto the cylinder, the radius, the horizontal
position of the wound image, and front and back side output for the image.
To apply the Cylinder effect
With the Cylinder menu displayed, set the following parameters.
Knob Parameter Adjustment Setting values
1 Luminance Luminance 0.00 to 100.00
2 Saturation Saturation 0.00 to 100.00
3 Speed Speed at which hue changes –12.00 to +12.00
Knob Parameter Adjustment Setting values
1 Radius Degree to which image is wound onto
the cylinder
0.00 to 100.00
2 Min R Radius of the cylinder 0.00 to 100.00
3 Offset Horizontal position of the image
wound onto cylinder
–100.00 to +100.00
To Next Page
Loading...
