Chapter 20 Switcher Setup (Switcher)
1195
Settings Relating to Keys, Wipes, Frame Memory and Color Correction (Key/Wipe/FM/CCR Menu)
Setting the default wipe edge softness
1
In the Switcher >Key/Wipe/FM/CCR menu, press [Wipe Edge Default],
turning it on.
2
Set the following parameter.
Setting the mode in which all signals can be selected for input to
the color corrector
Press [CCR Intrnl Signl Enbl] in the Switcher > Key/Wipe/FM/CCR menu,
turning it on.
You can select signals generated internally to the switcher as material for input
to the color corrector.
Notes
When you select an M/E reentry signal as material for input to the color
corrector, 1H delay occurs to the output signal of M/E.
Knob Parameter Adjustment Setting values
3 Soft Default value of wipe edge
softness
–50.00 to +50.00
To Next Page
Loading...
