Chapter 4 Keys
219
Key Setting Operations Using Menus
For an overview of the key types, see “Key Types” (page 210).
3
Carry out the following settings as required, depending on the key type
selected in step 2.
To enable clean mode (see page 211) for a luminance key, linear key or
color vector key: Select [Clean Mode] so that it is set on.
When clean mode is enabled, key fill is added to the background
without cutting out with key source.
When chroma key is selected: Select [Chroma Adjust] to access the
Chroma Adjust menu (see page 224), and make the required settings.
When a wipe pattern key is selected: In the M/E-1 >Wipe menu (see
page 293), select the pattern and set any modifiers, then return to the
M/E-1 >Key1 menu.
When a key wipe pattern key is selected: In the M/E-1 >Key1 >
Transition >Wipe Adjust menu (see page 319), carry out pattern
selection and modifier setting, then return to the M/E-1 >Key1 >Type
menu.
Notes
For a wipe pattern selected for a wipe pattern key or key wipe pattern key,
the [Edge] and [Direction] modifier settings are not available.
4
Set the parameters.
• When a luminance key or linear key is selected
a) Setting this value to 1, produces the “through” state in which no filter is applied. The larger
the value, the more strongly the filter applies.
• When a chroma key is selected
Knob Parameter Adjustment Setting values
1 Clip Reference level for generating the
key signal
+109.59 to –7.31
2 Gain Key sensitivity –100.00 to +100.00
3 Density Key density 0.00 to 100.00
4 Filter Filter coefficient
1 to 9
a)
Knob Parameter Adjustment Setting values
3 Density Key density 0.00 to 100.00
To Next Page
Loading...
