Chapter 4 Keys
220
Key Setting Operations Using Menus
• When a color vector key is selected
• When a wipe pattern key or key wipe pattern key is selected
5
Make the following settings as required.
To invert the black and white sense of the key source: Press [Key
Invert], turning it on.
To adjust the horizontal position or key source width for a luminance
key, linear key, or chroma key: Press [Key Position], turning it on,
and set the parameters.
To set the key priority: Press [Key Priority] or select VF7 ‘Misc’ and
HF3 ‘Key Priority’ to access the Key Priority menu.
For details, see “Setting the Key Priority by a Menu Operation” (page
166).
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 Y Clip Reference level for creating
luminance signal
+109.59 to –7.31
2 Y Gain Luminance signal sensitivity –100.00 to +100.00
3 C Clip Reference level for creating
chrominance signal
100.00 to 0.00
4 C Gain Chrominance signal sensitivity –100.00 to +100.00
5 Density Key density 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Y Filter Luminance signal filter coefficient 1 to 9
2 C Filter Chrominance signal filter
coefficient
1 to 9
Knob Parameter Adjustment Setting values
1 Size Pattern size 0.00 to 100.00
2 Soft Degree of edge softness 0.00 to 100.00
3 Density Key density 0.00 to 100.00
Knob Parameter Adjustment Setting values
1 H Phase Key horizontal position –4.00 to +4.00
2 Left Key left edge position –4.00 to +4.00
3 Right Key right edge position –4.00 to +4.00
To Next Page
