Chapter 7 Frame Memory
407
Frame Memory Clip Operations
To specify the playback start point
To set the current position as the playback start point, in the <Start TC> group,
press [Set]. To set a different position, press the [Start] status button, and enter
a timecode value from the numeric keypad window.
To specify the playback stop point
Start playback, and at the desired position press the [STOP] button to stop
playback, then in the <Stop TC> group, press [Set]. To set to any position,
press the [Stop] status button, and enter a timecode value from the numeric
keypad window.
To change the current position
To change the current position, press the [Current] status button, and enter a
timecode value from the numeric keypad window.
To delete the parts of a clip file other than the playback part
(trimming)
1
Set the playback start point and stop point.
2
Press [Trim].
A confirmation message appears.
3
Press [Yes].
Using the device control block (search dial) to play back clips
Notes
A frame memory clip must first be recalled with a menu operation.
1
With the device selection buttons, select the frame memory clip to be
played (FM1 CLIP to FM8 CLIP).
If the pair mode is on, both main and subsidiary FMs light.
2
Press the [PLAY] button, turning it on.
To stop playback, press [STOP] or any of the [SHTL], [JOG], [CUE],
[REW], [FF], and [ALL STOP] buttons.
For details of the buttons in the device control block (search dial), see
“Device Control Block (Search Dial)” (page 75) in Chapter 2.
To Next Page
Loading...
