Chapter 11 DME Operations
601
DME Special Effect Operations
3
Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
•4:3 mode
• 16:9 mode
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges
Value of Left shown
2 V Simultaneously adjust width of top
and bottom edges
Value of Top shown
3 All Simultaneously adjust width of all
four edges
Value of Left shown
5 Density Density of edges 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Width of top edge 0.00 to 6.00 (SD)
0.00 to 18.00 (HD)
2 Left Width of left edge 0.00 to 8.00 (SD)
0.00 to 24.00 (HD)
3 Right Width of right edge 0.00 to 8.00 (SD)
0.00 to 24.00 (HD)
4 Bottom Width of bottom edge 0.00 to 6.00 (SD)
0.00 to 18.00 (HD)
5 Density Density of edges 0.00 to 100.00
Parameter group [1/2]
Knob Parameter Adjustment Setting values
1 H Simultaneously adjust width of left
and right edges
Value of Left shown
2 V Simultaneously adjust width of top
and bottom edges
Value of Top shown
3 All Simultaneously adjust width of all
four edges
Value of Left shown
5 Density Density of edges 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
1 Top Width of top edge 0.00 to 4.50 (SD)
0.00 to 18.00 (HD)