Sony MVS -8000X - Page 602

Chapter 11 DME Operations
602
DME Special Effect Operations
Adjusting the position of art edges
1 In the Art Edge menu, press [Edge Position], turning it on.
2 Adjust the following parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
•4:3 mode
• 16:9 mode
2 Left Width of left edge 0.00 to 8.00 (SD)
0.00 to 32.00 (HD)
3 Right Width of right edge 0.00 to 8.00 (SD)
0.00 to 32.00 (HD)
4 Bottom Width of bottom edge 0.00 to 6.00 (SD)
0.00 to 18.00 (HD)
5 Density Density of edges 0.00 to 100.00
Parameter group [2/2]
Knob Parameter Adjustment Setting values
Knob Parameter Adjustment Setting values
1 Top Position of top edge –3.00 to +3.00 (SD)
–9.00 to +9.00 (HD)
2 Left Position of left edge –4.00 to +4.00 (SD)
–12.00 to +12.00 (HD)
3 Right Position of right edge –4.00 to +4.00 (SD)
–12.00 to +12.00 (HD)
4 Bottom Position of bottom edge –3.00 to +3.00 (SD)
–9.00 to +9.00 (HD)
5 All Adjust the position of all four
edges
Value of H shown
Knob Parameter Adjustment Setting values
1 Top Position of top edge –2.25 to +2.25 (SD)
–9.00 to +9.00 (HD)
2 Left Position of left edge –4.00 to +4.00 (SD)
–16.00 to +16.00 (HD)
3 Right Position of right edge –4.00 to +4.00 (SD)
–16.00 to +16.00 (HD)
4 Bottom Position of bottom edge –2.25 to +2.25 (SD)
–9.00 to +9.00 (HD)
5 All Adjust the position of all four
edges
Value of H shown